Triplett 3256 Datasheet download pdf (Page 4)

Installing Battery

Remove the Receiver from the bottom of the Transmitter by slid-

ing it downwards (towards the back of the Transmitter). With Re-

ceiver removed, remove the Transmitter battery cover by sliding

it open. Install a 9 volt alkaline battery taking care to position the

lead wires so the battery fits properly in the cavity. Replace the

battery cover.

Using the WireMaster HDMI

Making Connections

Connect one end of the HDMI cable to be tested to the Transmit-

ter and the other end of the cable to the Receiver. The Receiver

may be removed from the Transmitter so it may be used remotely

if the ends of the cable can’t be positioned next to each other. If

testing a patch cable, the Receiver may be left connected to the

Transmitter.

Autoscanning

Set the WireMaster HDMI 2 AUTO/MANUAL button to AUTO.

Set the ON/OFF slide switch to ON while observing the X-Test

display. If the Low Battery indicator is lit, replace the battery

before continuing. The red X-Test LEDs must slowly sequence

from left to right, from 1 to 9, and then reset to 1 and sequence

again to 9. This cycle should repeat until the product is turned OFF.

When first turned ON, several LEDs may light and the sequence

may not begin at 1, but after 9 lights, the product will reset and

start the sequence at 1. Observe the LEDs on the Receiver.

They must sequence from 1 to 9, in unison with the Transmitter

LEDs. If any LED fails to light in the 1 to 9 sequence, if any more

than 1 LED lights at a time, or if the LEDs light out of sequence,

the cable is defective. If LED 9 lights up Green, the pin 14 wire

required for 1.4 support is present. If LED 9 lights up Red, the pin

14 wire is missing and the cable will not support all 1.4 features

Note: Many 1.3 cables have the pin 14 wire, but they are not

properly constructed to support Ethernet, 3D, ARC, and 4K.

1 2 3 4 5 6 7 8

No comments

Triplett 3256 Datasheet Page 4