Triplett 3022 Datasheet download pdf (Page 20)

RESISTANCE MEASUREMENTS

X1 through X1K Ohms:

1. Insert test leads into VOM and COM jacks.

2. Set Range Switch to appropriate OHMS range.

3. Short test probes together.

4. Adjust OHMS ADJUST CONTROL until meter reads

zero ohms.

5. Connect probes to component to be measured.

6. Read ohms on OHMS scale (multiply value read by

multiplier indicated by the switch).

A fuse protects the X1 range against accidental over-

loads. If the fuse should blow, all OHMS ranges will

not operate.

DO NOT TOUCH circuitry while

making measurements.

DISCONNECT or ISOLATE the device being tested from

other circuitry.

NOTE: 1K equals 1000.

NOTE: The Polarity Reversing Switch has no effect in

the Ohms Ranges.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

No comments

Triplett 3022 Datasheet Page 20